Lightburn GCode Inverts Light and Dark on Photos - Snapmaker 2.0

I have a photo that I have dithered using imag-r.com using Norton tile method. Everything looks great in Lightburn using Threshold but when gcode runs on SM2, it prints as if inverted has been selected which is hasn’t. It also prints this way on the Lightburn dither options with the exception of grayscale at S-Value 254. @brent113…you have a lot of Lightburn experience. Have you seen this before? I started with LB 9.20 and have bumped down to 9.13. I am on SM2 firmware version 1.9.0. I have look

Snapmaker Image Inverting - Snapmaker - LightBurn Software Forum

Fiber Laser Test

Lightburn GCode Inverts Light and Dark on Photos - Snapmaker 2.0 - Snapmaker: where creation happens

Fiber Laser Test

Snapmaker Image Inverting - Snapmaker - LightBurn Software Forum

How to Invert your design in Lightburn software for Laser Cutting / Engraving

AUTOFOCUS new 10W Laser - how? - Snapmaker - LightBurn Software Forum

Lightburn with SnapMaker 2.0 350 for Etching - Snapmaker - LightBurn Software Forum

Image color is inverted - Uncategorized-to-sort - LightBurn Software Forum

Snapmaker 2.0 40w Air Assist - Snapmaker - LightBurn Software Forum

Fiber Laser Test

In SnapMaker the Lightburn red fill lines are laser engraved - LightBurn Software Questions - LightBurn Software Forum

Negative image toggle broken? - LightBurn Software Questions - LightBurn Software Forum

ATOMSTACK X20 S20 PRO 130W Metal Laser Engraver With Air Assist Laser Engraving Cutting Machine 20W Laser Cut 30mm Wood/Acrylic - AliExpress