Prints stuck at layer 2 with Prusa Slicer

I'm having some issues with progress estimates and the displayed current layer does not go past 2. Prints fine. Running RepRapFirmware 3.1.1 but the issue was also present with 2.05 before upgrading Update: The total layer count on this specific print is

V-Core 3.1 Commissioning Guide

Are you printing at the right temperature? – Tom's 3D printing guides and reviews

3D-Print Guide 3D Prima - 3D-Printers and filaments

Generalisable 3D printing error detection and correction via multi-head neural networks

Creality Ender 3 S1 Review: Almost Perfect

PrusaSlicer not leaving Horizontal Gaps – PrusaSlicer – Prusa3D Forum

New to PETG. I need help. Prusa i3 MK3. I used the Prusa slicer. The layers that did stick, stuck well. I used purple glue stick on the bed. I believe their

6. 3D Scanning and printing - Florent Lemaire

Support Interface layer stuck – PrusaSlicer – Prusa3D Forum