How to get inverse fill to follow outline without waste - Getting Started With LightBurn - LightBurn Software Forum

I have an fill layer I am trying to reverse I know i can put a box around it and get this Which does put most of the fill where i want it but it does not follow the cut outs of the original edges and it also has a ton of fill that is just a complete waste of time. Is there a way to get the fill i want to follow the edges with the tabs and not have so much fill where its not needed. Here is the file UR_Box.lbrn2 (597.5 KB)

How to get inverse fill to follow outline without waste - Getting Started With LightBurn - LightBurn Software Forum

How to invert engraving?! - LightBurn Software Questions - LightBurn Software Forum

Handbook of Green Chemistry - Tools for Green Chemistry [1 ed.] 9783527326457

Lightburn not responding in offset fill mode - LightBurn Software Questions - LightBurn Software Forum

Fill is reversed - want to do an outline but filling my whole shape - LightBurn Software Questions - LightBurn Software Forum

Filling outside the lines - LightBurn Software Questions - LightBurn Software Forum

Filling Shapes & Text etc - LightBurn Software Questions - LightBurn Software Forum

How do I invert (negate) a vector engraving? - Resources - LightBurn Software Forum

Filling too much - LightBurn Software Questions - LightBurn Software Forum

Fill instead of clear area - LightBurn Software Questions - LightBurn Software Forum

How to fill inside the vector lines - LightBurn Software Questions - LightBurn Software Forum

Outline and Fill Question - LightBurn Software Questions - LightBurn Software Forum

Setting a section to *not* fill - LightBurn Software Questions - LightBurn Software Forum

How to fill inside the vector lines - LightBurn Software Questions - LightBurn Software Forum

How to fill inside the vector lines - LightBurn Software Questions - LightBurn Software Forum