BUG] Additional retract when linear advance is on. · Issue #19982 · MarlinFirmware/Marlin · GitHub

i have problem on 0.2 mm nozzle and 0.1 mm layer height. Marlin.zip Marlin 2.0.7.1 And I tried to fix this problem, which worked properly by deleting the original retract, but then it crashed due to other retractions. the slicer is cura

BUG] Rapid changes of acceleration break linear advance when using

BUG] Linear Advance K Calibration Print stops extruding · Issue

Problems with Linear Advance · Issue #5222 · MarlinFirmware/Marlin

BUG] Motor stuttering with linear advance on TMC2208 since Marlin

bugfix-1.1.x] Marlin (Linear Advance) produces blobs on 90

Bug in Linear Advance 1.5, causes extruder motor to stop for

Linear Advance problems : r/ender3v2

BUG] [Bugfix 2.0.x] TMC2209 + Linear advance = Line stair for the

BUG] Motor stuttering with linear advance on TMC2208 since Marlin

BUG] Marlin 2.0 32 bit Linear Advance error · Issue #13040

Bug in Linear Advance 1.5, causes extruder motor to stop for

QUESTION] LIN_ADVANCE 1.5 -- extruder rattles *a lot*. · Issue

BUG] Linear advance: actual extruder acceleration slower than

2.0] Linear Advance step generation issue causing motor noise

Bug in Linear Advance 1.5, causes extruder motor to stop for