Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

Hey Guys, So I had to put in new thermistor recently, did some other structural changes (60mm height increase) and wired in a fan which isn’t currently connected. Yet now I am getting this issue with my hotend where once the print start the temperature drops even though it looks like the extruder is still rocking it. I ran PID autotune, stored the values, brought the bed and then the hotend up too 230C using Repetier. Then I dropped in the GCODE. You can see down below the temperature curve. T

Extruder Struggling - AO-101 & AO-100 - LulzBot

High-performance polymer 3D printing – Open-source liquid cooled scalable printer design - ScienceDirect

A perfect grid print.. How to solve? PLA, 200-60, Nozzle 0.5. Estep properly calibrated and flow (90) too but increased back 100 hoping it'll solve. CURA 4.8. Line width 0.5 : r/FixMyPrint

workshop « Midsouth Makers – Memphis Area Makerspace

3D Printer Review: LulzBot AO-101 - 3D Printing Industry

Extruder Struggling - AO-101 & AO-100 - LulzBot

Mosaic Palette Users I've been trying to get Klipper and my Palette 2s Pro to play nicely

TweakTown's Guide to 3D Printing: Part 1 - What makes up a 3D Printer?

A novel face mask design with improved properties for COVID-19 prevention - Laine Alby, Ajay Jayswal, Sarah Morris, Will McAtee, Vrishank Raghav, Sabit Adanur, 2023

E3D Titan Aero toolhead for Lulzbot TAZ

LulzBot Mini 2 Review

Now Print Abrasive, Solid, and Flexible filaments on your LulzBot® TAZ 6 3D printer without changing toolheads! The E3D Titan Aero PRO Toolhead for

E3D Titan Aero PRO Toolhead for LULZBOT TAZ 5/6 - IT-Works 3D